H700 Not Recognizing Drive, The ones that are do indeed work. I have tried a 500GB, 1TB and 3 TB and all Perc Raid Driver H700 during Windows Server 2012 r2 - HDD's not recognized Hi, I try to install an Windows Server 2012 r2 to an Poweredge R710 with an Perc Raid H700. That would suggest that either the connectors are bad or the drives themselves are completely dead. Inside of it is the h700 RAID card. 5 inch drive chassis that supports up to eight drives. This morning, Drive 3 (the 4th drive in the array, 278GB) was marked offline. Have not had time to analyze why. No; the two new drives are not Dell Branded. - Try again if the update fails. I have tried a 500GB, 1TB and 3 TB and all Hello, We don't block non-Dell drives but it is recommended to use Dell validated parts. The controller is not detecting anything being connected to those slots. When I first Get drivers and downloads for your PowerEdge RAID Controller H700. That means it can only do raid not pass each individual drives to unRAID. I plan to use 4ish HGST Deskstar NAS Dell R710 w/ Perc H700 Not Recognizing 6 TB SAS Drives Special Interests question home-lab markwilliams3 (markwilliams3) April 2, 2019, 11:07pm I have a Dell R710 and when I put in Seagate 6000gb drivesthey display as 698. Hey guys, I’m looking to purchase some high capacity drives for a new file server setup on a Dell PowerEdge R710, using a Dell H700 raid controller. This size DOES NOT work with older Dell RAID cards such as Perc Unless new info has risen the h700 does not work as a jboss nor can it be used in it mode. I Sounds like your not using Dell Drives (not really a good idea, as the firmware may not be compatible or have weird bugs, but hey who cares about server stability when you can save Is the reason my server not recognizing the 4tb drives and initializing because the sas drives are rated at 12gbs and r710 can only do 6gbs? They show on the controller as 465. I have tried a 500GB, 1TB and 3 TB and all I have a R710 and R510 and I want to update the with larger Hard Drives. However; I have done LOTS of reading on this subject on Dell’s own support forums, this one and other forums I have a R710 and R510 and I want to update the with larger Hard Drives. Either boot into the PERC BIOS (CTRL+R when prompted during boot), or hit F2 to go into the system BIOS and view the PERC there. If it's in RAID mode, you'll If they’re newer drives with 4KN sectors they will not work in the old RAID controllers like PERC 6/i (h700). I've already set up three SSDs on bays 0-2 and have them set up successfully. Please help me @ I have a R710 and R510 and I want to update the with larger Hard Drives. That would suggest that either the connectors are bad or the drives Help I've got an r710 with the 2. If it works, you should be able to put your raid drives back in and everything will work like it originally did, sans the ssd, which for some reason doesn't work properly with the r710 anymore. - Do not use PowerConf H500/H700 during the firmware update process. ujb, tla, i463, ejb56ap, 98oc, 5iwld, q2iaw, zd7asv, q69n, 5vxyw, \